|
|
|
| |
Auto spray Gun Cleaning and Routine maintenance |
|
| |
Auto spray gun after use, should clean spray guns and accessories at first. Cleaning suction feed type spray gun, the first coating can be dismounted, the suction tube to remain in the cup and then release the air cap ring 2-3, with a piece of folded cloth to block the air cap, then pull the trigger. This can make the paint flow back into the paint gun tank. However, when irrigation was also installed in the paint spray gun when not to carry out such operations, because the pressure is very low at this time, paint will splash out from the filling inside.
Use a cloth soaked in solvent wipe off residue. Then the cup into a little detergent to clean, trigger.The will emit cleaner, cleaning the feeding tube. Then remove the air cap, soaked in diluent or solvent, such as round with a straw broom-like brush or a soft brush cleaning clogged holes. The finishing holes are drilled, so can not use wire or nails clean these holes. Brush and solvent cleaning with a spray gun nozzle. Thinner soaked rag to wipe clean gun outside, pay attention to erase all traces of paint.
Don't place a long time to spray cleaning fluid, it would seal hardening, and undermine the roller effect. In different coatings using different gun, they will get better concealment. |
|
| |
【Back】 |
|
|
|
|
|
|
|
|
|
